VOLTAGE STABILIZER AVR2000-BM

Description

VOLTAGE STABILIZER AVR2000-BM for home application:

Use for 110v OR 220v household appliances: TV, computer ,audio, refrigerator, air conditioner…. etc.

2KVA voltage stabilizer for home performance:

110-220v AC booster or 220-110v AC step-down& Automatic Voltage Regulator

Input: 95-265Vac; Output:220Vac~8% or 110Vac~8%

Lighting protection(10KA)

Over& Under voltage protection

Over load& Over heat protection

Delay Safety cycle 10-30 seconds

Input & Output Voltage digital display

5V USB mobile charger

Separate control output universal sockets

2KVA VOLTAGE STABILIZE FOR HOME IMPORTANT SAFETY INSTRUCTIONS:

This manual contains important safety instructions that shout be followed during the installation and maintenance of the Protection Power. Please read this manual thoroughly before attempting to install or operate this Protection Power. This equipment can be installed and operated by individuals without previous training.

1. This equipment is available for 220/230/240VAC loads. Please verify that this model matches your load voltage requirements.
2. This equipment is designed for commercial use only. The manufacturer neither recommends nor knowingly sells this product for use in critical life support applications.
3. This Protection Power must be earthed at all times during operation. Connect only to a mains supply socket outlet with an earth connector. A means of disconnection of the mains supply should be within 2 meters of the Protection Power.

 

CAUTION

Although your Protection Power has been designed to assure personal safety, improper use can result in electrical shock or fire. To insure safety, please observe the following rules:

Turn off and unplug your Protection Power before cleaning. Do not use liquid or aerosol cleaners.

A dry cloth is recommended to remove dust from the surface of your Protection Power.

Do not install or operate your Protection Power near water.

Do not place the Protection Power on an unstable cart, stand or table.

Do not place the Protection Power under direct sunlight or close to heat emitting sources.

Do not place the power cord in any area where it may get damaged by heavy objects.

Do not overload or short circuit the Protection Power.

Follow all warnings and instructions market on the Protection Power.

 

VOLTAGE STABILIZER AVR2000-BM FOR HOME IMPORTANT INSTALLATION INSTRUCTIONS:

 

Inspection

Inspect the Protection Power upon receipt. The packaging is recyclable. Save it for reuse or dispose of it properly.

Connect to Utility

Connect the AC input power connector to utility power to power up the Protection Power.

The Protection Power can be connected to the utility power via the attached power cord and plug.

Follow the steps below:

1. Make sure that the Protection Power do not have any mechanical damages.
2. If necessary perform grounding of the casing of the Protection Power by connecting grounding wire to the corresponding terminal, or at least make sure that the mains outlet is grounded and available with 3 pins connection.
3. Plug in the Protection Power to 110-240Vac mans electricity outlet.
4. Turn on the input switch of the Protection Power and read the voltage meter if it has output.
5. Turn off the input switch of the Protection Power.

Connect the loads

Plug the loads into the output sockets of the Protection Power. Turn on input switch, after 15-40 seconds, turn on output switch and then switch on the load. Do not overload the Protection Power, check carefully of the power capacity of the appliance before connect it to the Protection Power. Make sure that the maximum power capacity of the appliance does not exceed the rated power of the Protection Power(see the specification table). when use the Protection Power for compressor or laser based equipment, make sure to choose a Protection Power with at least 3-4 times higher capacity than the rated power of the equipment.

Overload may cause serious damage to the Protection Power and the connected equipments.